Newcamd-how to configure the server or the client?

I set Newcamd and it works. But slow and very slow. There was a question - who is Newcamd:
- The server and the client,
- Server
- The client.?
We all think Newcamd-server!
Who is then the client?
If Newcamd client, who is server - Newcamd, Mgcamd, Cccamd ...?
If developers know the answer to this question, let him answer,
and then we just calm down!

Work week - received a preliminary response to my question. Newcamd is server and the client?

Newcamd can not be used as a client without having to connect any server somewhere, if I do, it starts to slow down.
When using Cccamd as a server to the client Newcamd work is often interrupted and so slow.

In STB Openbox S16 no pre emulator Mgcamd!!!
Therefore, to work with the client Newcamd can use emulators (server) Newcamd.

I tried this option and it turned out that it works better than the rest.

This bunch is configured in a standard way with use panel MENU - Network setting - Newcamd server setting
and blue button USB - set from USB flash - file for the emulator Newcamd - newcamd.cfg. Remember, clicking Exit, exit the menu, restart STB Openbox S16, after a short delay on the screen to appear picture.

Quote from Inspiral

this may help -

1. Press "Menu"
2. Scroll down to "Network Local Setting"
3. Press "OK" on remote
4. Arrow right to "Newcamd Server Settings"
5. Press "OK" on remote
6. Enter newcamd server parameter
7. Server setting -ON-
8. TCP Port -eg. "13000" this must be forwarded in your router
9. Des Key 01 02 03 04 05 06 07 08 09 10 11 12 13 14 (Can be change to your own)
10. Add USER in Newcamd server User manager with green button on remote
11. Add username PASSWORD "Allow emm YES"
12. Press yellow to save the configuration .

Now box is setup for server with 1 client and a reboot is always a good idea .

In the Client box with CCcam its the N: line to use for acces the server eg
N: server_ip_or_dns 13000 USER PASSWORD 01 02 03 04 05 06 07 08 09 10 11 12 13 14

Display More

Thank you so much! Valuable advice for owners Dreambox.
But a small problem, we are in another section of the forum.

In this section discusses the receiver without Linux on board, that is, Openbox S16.
In this section not are discussed Dreambox.

End of my Post. I tested 2 weeks 2 configurations:
1. CCcam - server, newcamd - client.
2. Newcamd - server, newcamd - client.
Faster and more stable than the first configuration works.
Files cfg. standard for CCcam and for Newcamd.