VU SOLO Clone - problem

I purchase a SOLO Clone
I put a BH 172 image for originale
I get power LED green, and after new image instalation LED from power turn to RED
--------------------
I purchase Cypress
I made the cable
I run BroadSTudio3
I select porcesor Samsung K9F1G08U0A
i get thei message
" THE BOARD STRAPPED FOR LITTLE ENDIAN MODE "
Offset was = 0X00000000 set , in Studio 3
please see in Image, link
http://img11.hostingpics.net/pics/854264solo.png
http://img11.hostingpics.net/pics/858666Cattura2.png
and this message
"the starting offet is in bad block.the operation has been terminared "
=======================================
I try to put inside CFE solo 2-- but I can'T
please some recommandation, to see were is the problem