DM800SE clone advise on flashing image

There are 3 replies in this Thread which was already clicked 3,496 times. The last Post () by nush.

    I am a complete newbie and need to make sure I don't mess up the box.
    I am going to flash my new box with this image. OpenPLi-2.1-dm800se-2012/08/12-sim2-SSL84b by aguda.
    After I have flashed the image will it work or do I press the back button on my browser and load in a patched SSL84B bootloader file.
    Sorry if I have asked a really stupid question.
    Thanks.

    Steps to Flash a box are as follows;
    1. Get the Proper Image for your box, has to be clone version and have the drivers for your tuner and processor.
    2. Get the SSL nfi file compatiable with your box. 82 84 84a or 84b
    3. If you have a USB stick test the image first on that. (see my post on this)
    4. You can put the box in HTTP mode by powering on the box while holding the front power button or the back mini flash button.
    5. Open the IP shown on the OLED via a net connected PC browser and load the Image first.
    6. Press the back button on the browser and load the SSL from 2. above
    7. reboot the box.


    Should be good to go.

    the bootloader is already in that image, just load the image, reboot when complete then setup, thats all i ever do and i havnt had a problem.

    dreambox 800hd se clone sim 2.10. pli2.1

Firmware, downloads and support for Dreambox DM800SE - DM800SEv2.

Your community resource for the Dreambox DM800SE - DM800SEv2 satellite receiver — firmware images, channel lists, plugins and setup help.