Flashed vix image on vu solo
Installed cccam and ipg
Went through wizard to setup but keeps coming up tuner not configured, when I did a scan initially it was finding channel names ok
Flashed vix image on vu solo
Installed cccam and ipg
Went through wizard to setup but keeps coming up tuner not configured, when I did a scan initially it was finding channel names ok
You have not told us how you have configured the tuner and for what satellites/static/motorized..If its a static dish for 28.2E this is how it should look..
its a s*y dish, i had the mode is diseqc, so will try configure in simple as its coming up as you have showed and when i do a scan channels are being displayed
what is the next step after this?
it is still stuck in the vix loadup screen so ive done something stupid
go into menu- setup and you should see tuner config.. go there , save after setting up and full reboot ,,then go into menu -settings and check
if all is well , either automatic scan for 28º or install catseye settings list for example tehn full reboot again
Didn't install channel list duh, Basic guide I followed didn't have this
Don’t have an account yet? Register yourself now and be a part of our community!