azbox premium plus want to update to openrsi software error install new kernel help

you need to follow tut to upgrade to enigma 2 and then install openrsi as the original software is enigma 1

Hi italiano1229

I installed OpenRSI myself yesterday and had the same problem. I managed to solve the problem before I saw replies to my help request post on OpenRSI forum, which gave a very good tutorial by antosat...

Get rti core 1.7 there is a patch bin file under officialtoE2 directory, then follow the below...

TUTORIAL: Official Firmware -> Enigma 2
1. Unpack archive, and copy file patch.bin to USB Memory stick formatted in FAT32

2. Plug-in USB Memory stick in AZBox and turn it ON

3. Choose update from USB

4. Wait that procedure is finished and that on VFD Display You get message Rescue Mode with an IP address, remove USB.

5. Start application called AzUP 2.2.7

6. Enter IP address which is shown on VFD Display of AZBox HD, Device select DOM, FS choose EXT3, Advanced options check two options. For more info look at picture from the OpenRSI tutorial.

7. Press GO! button under Install E2/Kernel , then it will ask You for patch.e2 file which is located in folder which You extracted from downloaded Enigma2 archive, choose it and press OK, after that wait until You get message from AzUP. After first restart receiver will go again to rescue, so restart it once more by long press Power button on remote control or by switching it off and turning on.

Hope that helps :)

Quote from italiano1229

i have firmware version 9.5402 i tried thru internet error fail to dowloads

Hi,

Upgrade by internet, and so without usb stick, is possible too.

You must change the url by this one:

and select this upgrade :

BEFORE THE UPGRADE, FIRST:

1. Make sure the "Hardware acceleration" is DISABLED, this is very important !!!!

2. Make sure you have a internet connection, and please use a LAN network cable.

Then you follow the jackhulk procedure from step 5.

Good luck!beer10

Quote from jackhulk

Hi italiano1229

I installed OpenRSI myself yesterday and had the same problem. I managed to solve the problem before I saw replies to my help request post on OpenRSI forum, which gave a very good tutorial by antosat...

Get rti core 1.7 there is a patch bin file under officialtoE2 directory, then follow the below...

TUTORIAL: Official Firmware -> Enigma 2
1. Unpack archive, and copy file patch.bin to USB Memory stick formatted in FAT32

2. Plug-in USB Memory stick in AZBox and turn it ON

3. Choose update from USB

4. Wait that procedure is finished and that on VFD Display You get message Rescue Mode with an IP address, remove USB.

5. Start application called AzUP 2.2.7

6. Enter IP address which is shown on VFD Display of AZBox HD, Device select DOM, FS choose EXT3, Advanced options check two options. For more info look at picture from the OpenRSI tutorial.

7. Press GO! button under Install E2/Kernel , then it will ask You for patch.e2 file which is located in folder which You extracted from downloaded Enigma2 archive, choose it and press OK, after that wait until You get message from AzUP. After first restart receiver will go again to rescue, so restart it once more by long press Power button on remote control or by switching it off and turning on.

Hope that helps :)

Display More

I gonna test this tonight, got yesterday a second hand azbox premium hd. And also got the issues mentioned above. Was still looking for a solution, but I think this is gonna solve my problem. If this isn't working, I will let you know. But for know I got a feeling this is the solution for the problems.