Problem setting up Diseqc 1/2 Motorised dish incorporating an Diseqc 1.0 A/B switch

There are 3 replies in this Thread which was already clicked 1,382 times. The last Post () by digi247.

    My setup has my motorised dish as port A and fixed 28E on port B. How can I set this up in Enigma 2 as I can't seem to figure it out, I can only get either fixed or motorised not the option to have 28E using port B for fixed rather than port A for the motor.


    Thanks in advance,


    MM

    You have to set it up as 'Advanced' then Diseqc 1.2 LNB 1 scroll to the very end when it asks 'Use USALS for this sat' select yes and put in your USALS co-ordinates do this for every satellite you receive apart from when you get to 28.2° east set this as advanced again but as Diseqc 1.0 LNB 2 and that should be it, and please dont panic as you go along for each satellite in the advanced menu when selecting LNB 1 it should remember your previous save for LNB 1 and repeat it for all the other sats

    Thats probably why most online retailers when selling Enigma2 receivers normally place a little tag line like this 'Sold to Competent enthusiasts Only' so that if your unsure on how to set it up dont buy it in the first place

Your resource for Enigma2 tuner configuration

Find tutorials and support for setting up DVB, advanced FBC, and USB tuners for satellite, cable, and other signal sources. Master your receiver's tuning capabilities. Find dedicated support and guides to configure DVB, FBC, and USB tuners for optimal satellite, cable, and digital TV reception.