C: line paramters for certain sid's

There is 1 reply in this Thread which was already clicked 653 times. The last Post () by shamonemf.

    All,


    Have tried looking for info on this but can't seem to anything.


    I have two c: lines, each with different sid's but same provider


    C: line 1 has sid's 000A, 000B and 000C
    C: line 2 has sid's 000C, 000D, 000E and 000F


    Problem comes when i am zapping channels. If i change tv channel to 000D, it takes long to get picture, because cccam first tries C: line 1 to see if the sid is available, then it tries C: line 2


    Is there anyway i can configure the C-lines, to only use C: line 1 for certain sid's and C: line 2 for other sid's


    Thanks

Your resource for CCcam softcam

Find downloads, configuration files, setup tutorials, and community support for card sharing and server management. Master CCcam configuration and card sharing. Access dedicated support, step-by-step tutorials, config files, and downloads for your Enigma2 setup.