messing around with raspberry using web interface when i thought why not add infra red detector ( i.r.d ) and use a real remote.
Having already raped my 5ky box for the hdd - ( and some other capacitors for another project ¬ namely Dirty electronics stuff )
i noticed it poking out from behind the tv.
I located the i.r.d on the front panel which i had already stripped of its plastic outer cover and snipped the 3 legged detector at the base where it joins the PCB with solder.
the legs are 1.5 cm long so there is plenty to work with so to speak.
i also butchered the GPi0 serial cable from the 5ky+ hd psu board that connects the main board so i had some pre made jumper cables that fitted correctly.
Using three separated cables i soldered them to the i.r.d pin outs and connected them as per the diagram in the schematic i've posted below
c16acd8ea3b.png
To my utter astonishment my samsung tv remote works the xbmc perfectly - button for button ¬
-
So to quickly recap -
1 take i.r.d out of sly+hd box
2 cut GPio serial cable at main board side and remove connector block side intact from power supply board side
3 separate individual cables and cut individual blocks
4 solder cable with connector block to i.r.d pin outs
5 connect to raspberry pi GPio interface as per schematic posted above
6 power up
7 try remote control - my samsung (BN59-00683A) remote works perfectly incuding VCR/DVD play fwd rwd pause stop buttons
whole operation should take 15 - 30 mins max.
And i found it very rewarding
Have fun joint10
:rikjaard1: