clock speed for jsc via card

hi ste witch card you have viacess or iderto are you on oscam

have you recieve slingcatcher

CAMKEY : /dev/sci1 00 00 00 00 00 00 00 00
CAMDATA : /dev/sci1 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
TRY ALL CHIDS : /dev/sci1
SMARTCARD CLOCK FREQUENCY: /dev/sci1 6800000

this is for iderto

this is oscam iderto

reader]
label = JSC
Protocol = internal
detect = CD
device = /dev/sci0
force_i***** = 1
Group = 1
EMMCache = 1,3,2
mhz = 600
cardmhz = 600
caid = 0603
ident = 0603:000000
camkey = 0000000000000000
camkeydata = 00000000000000000000000000000000000000000000000000 00000000000000000000000000000000000000000000000000 0000000000000000000000000000

You have to remember that not all cards have the same ecm times.

You cannot really compare a $ky card with a JSC one. Viaccess cards are normally around the 400-500 mark any way by my own past experience with my old TNTSat and Fransat cards. My old SECA Cyfra card was usually around the 0.350 msec mark and one of my Conax cards is as high as 0.800 msec.

NDS cards as a general rule of thumb are usually 0.090 to 0.130, although i have seen some people state they have got them down to 0.075 msec.

Just ask your peers if they are clearing off you OK. If they are whats the point of risking damaging your card just to try and get a few more milliseconds which probably won't make a lot of difference anyway.

Nano

nok is usually caused if the ecm being asked for is not one that your card can give.

I.e its for a channel that may be supplied by your provider but is not one that your card has entitlements for.

Nano