Hi All,
i hope that someone can help me to solve this problem.
I'm new in this world of flashing Receiver, but i try to forst the web to do this my self. But without your help i thins it will take some days more then planned ;-)
I have a receiver Amiko Alien 2 and i wont to install E2 with my C-lines. After Flashing the Box, it displa only "Boot" in the Box-display nothing goes to run.
In the Putty panel, i can see the the Environment for the U-Boot are damaged?!
U-Boot says:
Board: STx7105-PDK [32-bit mode]
U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock
DRAM: 256 MiB
Panel: VFD
NAND: Bad block table found at page 262080, version 0x01
Bad block table found at page 262016, version 0x01
512 MiB
SPI: ERROR: Unknown SPI Device detected, devid = 0x01, 0x02, 0x14
ERROR: Offset out of range (max=0xffffffff)
In: serial
Out: serial
Err: serial
Ident ic exist
Ident ic get stb id
IdentID : 0c 00 0a 00 00 11 bb
PDK7105>
thats all.
I need any help or suggestion.
Sory for my English.
Jokal
