Ive been scratching around and cant find how to set the remote back to standard so it works the box volume again i had it set for a samung tv and moving it to the room and this tv has code issues so just need to set it to how it was at first tried 2+7 and help 0002 but doesnt clear the remote volume code anyone know how to reset it apart from leaving the batteries out for days on end ?
Solo 2 remote
- stevejo
- Thread is marked as Resolved.
-
The book for the Ultimo says
QuoteDisplay More4. Mode Switch of Volume + / - and Mute
For the sake of easy volume control, please set the STB volume at 50% of the maximum level and set
this level as the default volume level from STB. Then, you just have to control your TV volume only without
having to adjust STB volume at the same time.
Set-up Sequence:
<<1 + 6>>, <9>, <9>, <3>, <TV Power or STB Power>1. Press 1and 6 for three seconds until LED is on.
2. Press <9>, <9>, <3>.
3. If you want to control of TV volume, press TV Power button. If you want to control STB volume, press
STB Power button.5. Reset of TV Set-up
In case you want to reset the configured TV set-up of your RCU,
Press Sequence:
<<1 + 6>>, <9>, <9>, <6>
1. Press 1and 6 for three seconds until LED is on.
2. Press <9>, <9>, <6>.
3. This will reverse the RCU into no configuration state. -
master G
Moved the thread from forum Vu+ SOLO2 Support to forum VU+ SOLO 2.
VU+ SOLO 2 PVR Ready Linux Enigma2 Receiver Full HD 1080p
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
