Priority question

There is 1 reply in this Thread which was already clicked 767 times. The last Post () by thatfellow.

    Hi
    I run my 093E card in an external OScam server (Raspberry Pi)
    In my DB8000 I run CCcam via newcamd.conf
    I also have access to external cards.
    When I restart CCcam, I want it to select my card as priority 1, but it does NOT
    How will I get to this (assuming it goes without disconnecting the external resources)
    When I ran NewCs the choice always was my card after restart of the cam


    //guess

    This might be an all time record, You are a member 2½ years & this is your first post and no introduction..


    Please Read the rules here
    Forum Rules


    Then make an Introduction here as required by Rule <1> above
    Introductions




    All your problems have been solved countless times before so try the search box before you post!!
    Please do not Request help by PM, use the main forum so Everyone can benefit from the answers.

Your resource for CCcam softcam

Find downloads, configuration files, setup tutorials, and community support for card sharing and server management. Master CCcam configuration and card sharing. Access dedicated support, step-by-step tutorials, config files, and downloads for your Enigma2 setup.