the box boots up the channel loads in, the wheel is turning in the top right hand side it stays like that for about 60 to 70 seconds then shuts down and restarts over again in a loop.
I thought it might be the hard drive so I replaced it with another one but still the same,
so I took out the hard drive reinstalled the prismcube official FW 1.2.2 and rebooted, then the BH 1.2.2 FW and rebooted, then put in the replacement hard drive and rebooted, then I rebooted again when it fully loaded up, put mg*camd in to temp with ftp and install at this point everything is working grand, I can install fusion or xfinity, channels are working fine
but if I ftp in and add or make changes such as the channelLogo.xml or add a picon, the box goes back into a loop, strange thing is I was able to make changes like this before