Hi All,
I have an Opticum X7 that when powered up just displays the lcd time 0000. It will not boot at all. I checked all psu voltages and all appear ok.
Any suggestions.
X7 HD boot problem
- hs5424
- Thread is marked as Resolved.
-
-
Yet again I have a problem with an X7 during boot. This receiver will display 'BOOT' and then 'ON' and thats it.
I tried to reflash it with sw 1.3.81 but it goes to 87% of the process and stops. I tried 1.3.41 and got a notice on my PC about wrong boot loader. This problem during a full Auto scan installation. I am using the rs232 cable option.
Any Ideas.
Thanks in advance. -
Yet again I have a problem with an X7 during boot. This receiver will display 'BOOT' and then 'ON' and thats it.
I tried to reflash it with sw 1.3.81 but it goes to 87% of the process and stops. I tried 1.3.41 and got a notice on my PC about wrong boot loader. This problem during a full Auto scan installation. I am using the rs232 cable option.
Any Ideas.
Thanks in advance.use the tool from the Ariva A200
-
Thanks for you reply,
I will give it a go. -
Hi szprot
Tried the Ariva 200 loader.
Looked good at first as it now went to 100%. When finished I got a notice 'sdram fail'. -
Hi szprot
Tried the Ariva 200 loader.
Looked good at first as it now went to 100%. When finished I got a notice 'sdram fail'.Eureka,
Tried older sw first with the loader you suggested and all worked 100%. I will try some of the other boxes that I was having similar problems with.
Thanks again sdprot5
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!