After a recent move i had the pleasure of re-installing my motorised satellite dish ! :dribble:
first i did make sure the pole was plumb
d54a589cfd0b07.jpg
too make sure the pole is plumb i checked both sides at right angles
6278c04cc83e6716f.jpg
After everything is plumb and tight with spanners,the pole and brackett is ready to accept the dish !
At this stage the dish should be attached to the motor ! And i always use U.S.A.L.S and set longitude & latitude then drive dish to 28.2e
8d69e6350683476108.jpg
all that is needed now is to align dish to 28.2e hand tight everything ! go inside and check arc to ensure other sats are being recieved ?
If you got it spot on you should now have the ability to receive all sats with given dish size ! i have 78cm triax and got a good arc 30e-30w
ad89ef068bdc79c145a8c36.jpg
here is finished dish install !
perhaps later i can upload some screen shots from various sats along my arc ! welcome10
Rik
