Lads have two dm500s can't get them to flash using dream up was able to use the erase image seemed to work no problem but when I try to flash a new image on the it says abort message tried different versions of dream up but still the same changed power cable still no joy hope some one can shed abit if light on this thanks lads
Dm500s won't flash using dream up
- tennents
- Thread is marked as Resolved.
-
-
Is this by using a laptop or PC ??
-
I use a pc I've allways used it to flash them before no problem it's strange why it's letting me use the erase image but won't let me flash any images as it aborts
-
Did u Try Dreamup v1.3.3.7
-
Try Flash Wizard 6.4
My Dream Toolbox v7.3 might also be of use.. -
Cazuela I can't get into the box to get the ip address to use flash wizard after useing the erase image mate
-
I've tried ever different versions off dream up with no joy
-
You tried a diff 232cable m8?
-
Done that allready got a lend off a mates still no joy the one that I own works no problem tried it on anymore dm500s same pc and it flashed no sweat going to try an older pc tomorrow to see if that works but when I've flashed those other two box with the erase image u can see them taking it as when it starts programming the box the led light on the front of the box's flashes red so I no there taking the erase image its me baffled lol
-
master G
Moved the thread from forum DM500 - DM500s Support to forum Enigma1 Support.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!