i instaled 04.06.2014 openbox x5 firmware.two weeks it runs properly.Now it does not work and reboot.I follow the recovery methord properly.But it does not work.Pls any one help to me.Thanks
Openbox not working
- kanaguraja
- Thread is marked as Resolved.
-
-
i instaled 04.06.2014 openbox x5 firmware.two weeks it runs properly.Now it does not work and reboot.I follow the recovery methord properly.But it does not work.Pls any one help to me.Thanks
Perhaps you should read the rules and make an introduction post first.
then open a thread and ask your question in the right section.
untill then I doubt anyone will help you. -
@ kanaguraja
I have moved your post to the appropriate section.
It may get more responses here.
Please don't hijack threads and also post an introduction as per forum rules.
You can do that here:
http://linuxsat-support.com/forumdisplay.php?f=2 -
Is it the x5 super or just the x5? Try and reinstall the software via the usb here is the latest software for the x5 i also have the latest x5 super software
-
It may have 3 resans
1use this metod.
How to Boot from USB drive?
Step 1: Create “recovery” folder in USB drive
Step 2: Copy KD_P9000E_HD.bin file to the “recovery” folder of USB drive.
Cautions)
1. USB drive shall be FAT32 file format. Its doesn’t support NTFS format.
2. Only one related .bin file shall be in recovery folder.
3. Do not change the file name. If it is different, the boot from USB will not work.
Step 3: Attach the USB device to the STB via any available USB port.
Step 4: Turn power on while pressing OK key on front panel.
Step 5: Keep pressing OK key until showing “Lxxx” message on LED of front panel.
Step 6: Check TV screen that s/w is recovering(updating) by USB drive.
Step 7: The STB will restart automatically after finishing s/w recovery (update).2
Reason 2: Processor not good connect with GND.
Method 2: Soldering the tin of Processor.Step 1: Take out X5 Motherboad.
Setp 2: Use soldering machine, to make processor to conect well with GND3
Reason 3: Conponents problem.
Method 3: Change Flash Memory IC or Cystal 27.000MHz..Step 1: Take out X5 Motherboad.
Setp 2: Change the Flash Memory IC ( position: U15) or Crystal ( position: X1) -
master G
Moved the thread from forum Openbox Support to forum Openbox | Skybox.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!