Icecrypt S3700 stuck on boot

There is 1 reply in this Thread which was already clicked 1,065 times. The last Post () by sparky stu.

    Hi, I have a Icecrypt S3700 that shows boot on the lcd all the time and won't boot E2 or back in spark.



    Board: STx7105-PDK [32-bit mode]



    U-Boot 1.3.1 (Jun 19 2012 - 17:10:44) - stm23_0051 - YW_1.1.005 overclock


    DRAM: 256 MiB
    Panel: VFD
    NAND: Bad block table found at page 262080, version 0x01
    Bad block table found at page 262016, version 0x01
    512 MiB
    SPI: info: found S25FL016K (2MiB) device (page=256,erase=65536)
    warning: SPI device may be write-protected (status=0x9c)
    In: serial
    Out: serial
    Err: serial
    Ident ic exist
    Ident ic get stb id
    IdentID : 0c 00 2b 00 00 01 e6
    Hit ESC to stop autoboot: 3


    any help would be much appreciated.

    I have a 3700 with the same issue, I spoke to Ray at Icecrypt several months ago and he seemed to think it was a fault in the boot loader, he asked me to return back to him as not something that he can give out the software for. As to date I have not bothered as I just put my old Alien 2 back on instead.


    Sorry this may not be the answer you were after, but I will say. I have found Ray to be the most helpful person in any companies tech support and will do whatever he can to help.

Spark STI 7162 Support

Support for Amiko Alien 2, Delta, Dynavision 7162, Galaxy Innovations Avatar 2, Galaxy Innovations Avatar 3, Golden Media Spark Triplex, Golden Media Spark One, Icecrypt S3700 CHD, SAB Unix Triple HD, Samsat Linux 2, Satcom 7162, Sogno Spark Triple, Startrack SRT 2020 HD Plus, Superbox Z500, Truman TOP-BOX, Truman TopBox 2 Tuner, Visionnet Falcon, Spark STI 7162 Receivers.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login