Stuck on ip & not booting.

There are 4 replies in this Thread which was already clicked 638 times. The last Post () by Baldoyle FTA.

  • DM 800 SE Clone.
    I have loaded bootloader & then image, flashing and finishing of with no errors.
    But just wont kick onto tv screen.
    I also noticed the screen on the box is very dim, just being able to make out ip.
    Flashed with serial and from telnet but still wont boot onto tv.
    So its no problem flashing just the boot onto tv & ip showing & stop on box.
    Any ideas or is it dying. tried different power supplies as well so no problem there.
    Also scart & hdmi.

  • I'd try another image, I've had that problem before, reflash with another image cured it


    Thanks, but have tried a good few & still the same. Think it could be a hardware problem at this stage. Might look out for a broken one & see if I can make one from both. Will have a look at a few chips inside & get me soldering torch out.

  • I used a 14v one just to see if it would sort it, but cut the box off.
    Used another 12 v one from another working Dreambox & that didnt sort it either.
    Will report back further when I try something else, just in case we see this again.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!