I have tried so many times to install OpenElec on NAND and each time I crash the box,yesterday
evening I had to do recovery 4 times.when I download the files there are 3 files + a zipped folder
(Stack of books) ,now do I put the whole thing on a SD card or just the three files.i have tried both
ways without luck. I power off and insert card and while holding the pin down on the bottom I power
on again and wait but no matter how long I wait I just get black screen and no signal. Any help
would be appreciated.
OpenElec on nand
- toothfairy
- Thread is marked as Resolved.
-
-
-
Ah I was trying the middle one seeing as I had just done a recovery.
-
so you've now used the top one?
has it worked?regards: canthackit
-
so you've now used the top one?
has it worked?regards: canthackit
Not yet I haven't had a chance but will this evening hopefully.
-
If you are wanting to do a fresh install, which it sounds like you are then it's this one that you need to use: http://releases.openelec.tv/Op…WeTek_Play.arm-5.95.2.zip
-
If you are wanting to do a fresh install, which it sounds like you are then it's this one that you need to use: http://releases.openelec.tv/Op…WeTek_Play.arm-5.95.2.zip
At long last I have got OpenElec on NAND thanks to the above post by jim1985, I
would also like to thank everyone who helped, -
I am failing at this also, I've tried all links on this thread.
I hold down the upgrade, but I dont get the upgrade screen, just goes blank, and my tv says no input. I have to do a wetek image restore to even get anything on screen. -
Try this one
https://mega.nz/#!6ExWWDJL!vcf…Sj5zGifmK_zNkkEIO3sUfNcSc
Don't forget to format the mSD card with SDFormatter
Make a full erase
WeTek device support.
Firmware, downloads and support for WeTek satellite and Android media devices.
