You dont have any softcams installed. Grab the softcam ipk from on here . Then follow these steps (this is something knocked up for openatv) but it should be broadly similar for vix. Remember this for mgcamd but again should be similar for ccam. When you use cccam though you dont edit newcamd.list you edit cccam.
1. Get the softcam ipk file' and save it to your pc (e.g desktop);
2. using filezilla ftp to your box;
3. In the left hand margin of filezilla scroll to where you have saved the ipk file. For example, if it was on your desktop you would click on desktop in the top left pane;
4. Now go to the box files right hand pane > scroll to tmp and click on it to open the tmp files;
5. Now back to the left pane > click on the ipk file > right click > choose upload. This transfers the ipk file to tmp on your box.
6. Now on your remote control press menu > setup > software management > scoll down to install local extension > press ok > scroll to memory /tmp > ok > ok > green.
7. After installation you might need to reboot (might not);
8. Press menu > plugins > download plugins > softcams > scroll down to mgcamd 1.38 or 1.35 > ok > yes;
9. Press blue > softcam > softcam panel > your cam should be showing > blue to install > then green to start.
That should be the softcam up and running now you can follow the instructions above to install your line.
Note: Sometimes when the softcams are installed you will see the files in /usr/keys all end in example. You can just delete that part of the file. e.g newcamd.list.example - delete example.
