Install Mgcamd on VU+ Duo2 Blackhole

There are 3 replies in this Thread which was already clicked 2,594 times. The last Post () by Prophet.

    Hello,


    I believe i have installed this correctly via http://linuxsat-support.com/showthread.php?t=84564 based on image below


    6585219a3a45a.jpg


    Reading other parts of the forum i need the mg_cfg and newcamd.list in usr/keys


    I understand the layout for newcamd.list
    CWS = Servername Port Username Password DESKEY wan newcs from master G's post here http://linuxsat-support.com/showthread.php?t=5152


    Do i need to change anything in the mg_cfg
    The box was originally set to 06 but have changed to autodetect
    The username and password auto gets pulled from the newcamd.list
    The IP and port showing for UDP would i need to change?


    Just trying to understand the requirements fully


    Regards


    Juggy

    Looks like you have installed Oscam m8, the files you are requesting are for MGCamd. If this is what you want then got to post #4 from link in your post and the MGCand is attached by Master G/


    :09:

    Vu Duo4k SE Running OpenBlackhole


    MultiSat


    Panasonic 55" 4k OLED Model TX-55902B

    Thanks for the info, but thought as i Installed the "All soft Cam installer" that covered them all?


    Will have a bash at just the MGCamd now


    - - - Updated - - -


    Okies all sorted i can see everything now thanks for the info ;-)

Your resource for Mgcamd softcam

Find configuration files, setup tutorials, downloads, and community support for efficient server and client management. Master Mgcamd configuration and management. Access dedicated support, step-by-step guides, config files, and downloads for reliable card sharing.