Hi
Lost all channels (FTA ok), thursday night, everything just froze, tried restarting box,modem,cccam etc., but still no picture.
Next day tried all above again, tried reinstalling ccam and N Line, still nothing,
So reinstalled Vix image, but image not now loading. So updated to new VIX image and new bootloader, loaded ok
installed ccam etc but no picture other than free to air, these then started to stick, so reloaded VIX but this time not loading.
Have since tried other images, all loaded but can not get anything other than FTA.
Any ideas would be welcome. All working well before thursday evening.
Currently using
Xtrend ET9000
image - dreamboxuk
ip - virgin
Have tried other images HD Freaks, Openpli but have same result only FTA channels.
I have another box(dreambox800) which is working ok
Thanks in advance
gmth63
xtrend et9000 help
- gmth63
- Thread is marked as Resolved.
-
-
I use Egami so not too sure about Vix. Is your Cccam actually active (running)? Does it say your lines active?
-
-
Hi
CCcam running, but not showing any connections, have changed image again this time to clarketech image V3., but still only fta channels.
thanks -
Will you please show us how you are entering the line?
Also i'm cautious is it a test from a payserver you got or a free cline you found on the net?
-
entering the N line into the cccam.cfg in etc., tried this line in adifferent box and it worked.
its a paid for line which was working ok, suddenly froze thursday evening, have tried another line from different person which works in another box ok.
I t would seem something happened while watching tv that has caused the problem, all had been working well for months.
thanks -
If you are using cccam with vix are you using the right one for the vix image "enigma2-plugin-cams-cccam.2.2.1_1.0-r0_mipsel"
and you need to do a online update on latest vix 2.3 as this fixes a small cam bug that existed on release
also add this to the top of your config file "ALLOW TELNETINFO=YES" it helps with the built in cam check program
Vix cams can be found here ViX Softcam Collection.
-
Hi
am using clarketech image for moment, with same results as above only fta channels.
the new vix image wont now load, gets as far as booting but goes no further.
have put "ALLOW TELNETINFO=YES" into cfg but still same result.
when changing to a uk gold etc it comes up at bottom of screen with 'No info from emu or fta'will try flashing vix again tomorrow.
thanks
-
-
Hi
tried flashing vix again but does not go beyond booting, tried a few times leaving for 20-30 minutes but stays at booting.
thanks -
Hi
tried flashing vix again but does not go beyond booting, tried a few times leaving for 20-30 minutes but stays at booting.
thanksIts known as stuck in boot loop, you will need to reflash again.
-
Hi
Thanks to all, have sorted it now, all working.
It would seem the cfg had become corrupted some how, and each time
I put a line in it added to the front of the line, could only see this when rechecking it,
dont know how it happened but now all ok.
thanks -
master G
Moved the thread from forum Clarke-Tech | Xtrend Support to forum Xtrend - All Models. -
master G
Moved the thread from forum Xtrend - All Models to forum Xtrend ET-9x00. -
master G
Moved the thread from forum Xtrend ET-9000 to forum Xtrend - All Models.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!