dead ping..........................
Posts by cazuela
-
-
?made in china.........................???
-
when the match is with an english team,,the audio can be switched over to english commentary...try any of them..
-
could always check frequencies,give the LNB a wipe ,as its birdsitting time ,etc, I said sitting,,,,,you never know your luck!!
-
fireplace.............
-
catching my drift....................
-
before you replace it ,check the angle it is at,,as you?ll need to know to fine tune the signal strength to maximum..
usually just two screws holding it in place.. -
so it seems..................
-
in my gemini___ remote control_menu-adjustments-advanced adjustments -network card adjustments-
configure your card to the IP you choose
or in the hard drive _for example C -then open programmes-find your version of Cccaminfophp or cs studio ,,
open it - inside you will see a folder called htdocs -open it..then you will see the IP of your box ,,,,,,,
as a side note ,if you ever want to "refresh" your caminfo ,simply eliminate the folder with 192.xxxxx and nxt time yuou open your caminfo you will see a"true" reading of your CCcam... -
-
remember to restart the box with the remote control ,as a simple reboot in telnet wont save the change..then when you open DCC ,remember to put the new pass if its not there already..
-
if you keep an uptodate softkey file you?ll have Biss ;)
-
the knowledge.......................
-
now and then...
-
careful which port you leave open for streaming through the net,,,,,,,,,it means its open for one + all,,,so protect it well with pass....
-
and while you?re at it make sure its HD ready...lol
-
through DCC you can find out the box IP or simply open adjustments and look at the network card..then change it either in the network card or the caminfo...
-
using gemini image 4.70 and CCcam 2.1.4 ,first i registered with site: http://www.techniradio.de/Technik/index.php?contentID=2 making sure i put the correct number in the correct place:the ticket number is the one on scratch card ..the serial number is the one beside the chip on the smartcard(in my case a sticky had the serial number but different codeand so wouldnt register first time) then in CCcam.cfg i opened this: B: /dev/sci0 00 to ensure that there could be no blockages of EMMS(although this is already configured as default, I simply eliminated the #) and so left it on MTV HITS in 19?E conax ,it started to recieve ECMS + EMMS ..i have tried out the various channels and working 100%.... hope this and ddaddy?s experience helps out others.....
-
it?s our baby................
-
rock with me......