High Ecm when using oscam

There are 4 replies in this Thread which was already clicked 2,689 times. The last Post () by Chris2005.

    Hi All


    I'm currently using cccam on my vu+duo2 to connect to my debian server which is using oscam


    With cccam my ecm time is 96ms but with oscam its 115ms


    I've also noticed when I turn on the internal share with oscam my freind which is connected through newcamd ecm times go from 92ms to 147ms


    I've installed the latest oscam version 10998


    I dont need DVBapi could this be causing the problem ?

    • Official Post

    Which reader are you using, omnikey, smargo etc ? Show us the [reader] config from oscam.server.


    dvbapi parameter is only for watching tv, it`s not needed on a server that is only reading a card, you can remove it.


    I`m getting 97ms on a uk card & omnikey with this config:

    Hi Master G


    The debian server is working fine and is is used as my server and reads my card


    The problem is when I use oscam on my vu to connect to the debain server the ecm times are higher then when using cccam and for some reason my freind which is connected through newcamd to the debian server times are getting higher also



    The vu is used to watch tv in the house only and has no other connections


    - - - Updated - - -


    Hi Master G


    On the vu Duo is there anyway to turn off dvbapi so its not using it as a client


    When I remove it it seems to stop the share from my server

    Hi Stevejo


    I've been getting a few glitches with cccam and thought oscam to oscam might have been a better solution


    Just experimenting with a few different things

Your resource for OSCam softcam

Find configs, downloads, tutorials, and support for setting up and optimizing this open-source card server with wide protocol compatibility. Master the versatile OSCam softcam. Access support, configs, tutorials, and downloads for open-source card sharing and multi-protocol server management.