Hi
VU+ Ultimo
When I do a Satfind or Manual Scan in Service searching for 28.2 the LNB on the motoe gets power and all is well, but then when I go to 28.2 to view the channels the LNB get turned off. All is OK on 19.2 - 16.0 - 0.8w it just 28.2.
It has to be a setting but I can't find it.......anybody help please ?
No Power to LNB at 28.2
- turbo2
- Closed
- Thread is marked as Resolved.
-
-
have you checked in config mode that lnb is showing lnb1 and not showing not available?
-
have you checked in config mode that lnb is showing lnb1 and not showing not available?
Hi
Yes it is showing not available, but there again tried to make it available :-(My setup is 3 tuners, 1st and 2nd to twin LNB and 3rd tuner on motor. Has anybody done a read me on setting this config up?
-
so all you need to do is set up your 28.2 to what ever lnb you wish, are you using usals?
-
Yes using Usals.
It only looses power when I select 28.2....all other settings are getting power and working, its just 28.2 -
Sounds daft, but I had a problem like this, an f-con was too loose and when the dish turned to a certain angle the power died. I think that what must have happened anyway, because after getting up and tightening them all, it's worked like a dream since.
Probably way out, but thought I'd throw it in the mix.
-
better yet check the LNB config on your decoder .........
cheers
-
hi make sure youre satellites.xml has got 28 east on it or it wont work ???
-
Just checked the connections were good, just nipped them all with an 11mm spanner to make sure, and it get power and works in that position when I do a sat scan.
The config for that tuner is
SIMPLE
POSITIONER
MY LONG
WEST
MY LAT
NORTHAre there more configs on these setting other than going into a different Config Mode and Mode other than SIMPLE that need to be config ?
-
hi make sure youre satellites.xml has got 28 east on it or it wont work ???
just checked and it is listed.
Thanks anyway
-
SORTED
Turned the STB off at the main switch, left it for 30 second, powered it on and it it is OK now.
Thanks for all your contributions :10_002:
Enigma2 DVB - FBC - USB Tuners
Enigma2 Tuners. Articles, Downloads and Support for DVB-S2 Tuners, DVB-S2X Tuners, DVB-C/T2 Tuners, DVB-C USB Tuners, DVB-T/T2 USB Tuners, DVB-T/T2/C USB Tuners, FBC Tuners, and Tuner Drivers.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!