recently switched to cable and using a vu solo se v2 with vix image.
not used cable on cs before as always been with sat.
ive had a few issues with pixelation and was advised it could be the signal.
so ive had a look under service searching and signal finder to look for the signal strengths.
i get a screen with 3 elements
SNR
AGC
BER
they are all 0% but the AGC one flickers up to 92% on both tuners.
from the connection point in the front room I have a feed going into a splitter which has a db boost on it and this is split into the box and router.
does it look like I have an issue with my set up?
next thing i was going to try was to flash the box again.
using vix but may be tempted to look at others too