Hi all VU+Duo, Oscam v6337 Ccam V2.3 sly local card, shows down on CS Studio until I restart the cam (blue button) then it clears, other peers shares seem ok, this has happened before, any ideas please
local card, shows down on CS Studio until I restart the cam
- junger
- Thread is marked as Resolved.
-
-
Use the OscamCheck Script for Vu+ BlackHole image, works perfect.
-
Thanks master-g, I have tried this before but just to be sure I tried it again.
FTP (OscamCheck Script for Vu+ BlackHole image) and I load it into temp, then green/yellow button, I get the error,
the screen shows
"Installing ipknew enigma2-scipt-oscam check " etc x 3.
sh: /tmp/opkg.V038rr/ipkkknew: not found
preinst script returned status 127
Collected errors
Aborting installation of ipknew enigma2-script-oscamcheck-BH
Cannot find package ipknew enigma2-script-oscamcheck-BH
execution FinishedHelp please
-
I have reuploaded the script, download and try again now.
-
Thanks master g, that worked first time
When I use the killall command in telnet i get the following
Killall: cannot kill pid 19170: No such process
Killall: cannot kill pid 19171: No such process
Killall: cannot kill pid 19172: No such process
Killall: cannot kill pid 19174: No such processIs this right?
Sorted thanks
-
Quote
When I use the killall command in telnet i get the following
wait a few minutes and check var/log/oscam_restart_log.
You should get process was not working, which means the script is working and oscam was restarted.
-
master G I get same message as juger get
Killall: cannot kill pid 9509: No such process
Killall: cannot kill pid 9510: No such process
Killall: cannot kill pid 9511: No such process
Killall: cannot kill pid 9778: No such process
i think some wrong with this script?it kill EMU AND naver restart EMU -
check var/log/oscam_restart_log and what do you see ?
-
I can not see anything on var/log i run Oscam6059+CCcam213-S*k_UK-E2-BH do we need change on config to get oscam_restart_log???
-
When you install this ipk make sure you do a full reboot of the system for it to take effect, then try again.
-
i done e2 reboot i will do it full reboot now and let you know
-
Do a hard reset and you will see in oscam.log that script works every 5 min and write log, Enigma2 restart wont setup the cron for the script.
-
same message is not working killall command in telnet
Killall: cannot kill pid 9509: No such process
Killall: cannot kill pid 9510: No such process
Killall: cannot kill pid 9511: No such process
Killall: cannot kill pid 9778: No such process
and not any log file???juger please tell us how did you Sorted?? thanksedit:is working now but take 4 to 5 minutes
and i get on oscam_restart_log this massage -
Correct, the script is set to run every 5 minutes, anything shorter than that will use too much resources on the Vu+.
-
thanks Mater G for all your help m8
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!