Boxnation not working on ubuntu 10.04 cccam 2.1.4

    • Videoguard2 Cards OSCam
  • mtv1
  • Closed
  • Thread is marked as Resolved.

There are 7 replies in this Thread which was already clicked 2,220 times. The last Post () by master G.

    Hi guys have ubuntu 10.04 cccam 2.1.4 server running sweet as a nut .. the only down fall is no boxnation so i need to add oscam ,, so this means i need to change cccam to 2.1.3 and put oscam in would i be better off completely reinstalling the lot or is there a quick fix :)

    Quote from mtv1

    Hi guys have ubuntu 10.04 cccam 2.1.4 server running sweet as a nut .. the only down fall is no boxnation so i need to add oscam ,, so this means i need to change cccam to 2.1.3 and put oscam in would i be better off completely reinstalling the lot or is there a quick fix :)


    reinstall the lot as in format and start over or just redo your cams? I'd redo your cams :)

    yes agreed ;) wouldn't i need to redo the rc/local to start oscam first ?? i seen it some where here before thanks sandman :)

    thanks for the support i used oscam cccam auto install script from youknowwho ;) copied my cccam cfg files used ominekey card reader in oscam with this setup { slyuk card }


    [reader]
    label = my-***
    protocol = pcsc
    device = 0
    showcls = 0
    fallback = 1
    caid = 0963
    ecmwhitelist = 0963:3E,42,44,45,47,4E,4F,53,54,61,62,67,68,69,6A,6B,6D,6F,71,72,73,77,78,79,7A,7C,7D,7E,80,8B
    detect = cd
    mhz = 600
    cardmhz = 600
    ident = 0963:000000
    group = 1
    blockemm-unknown = 1
    blockemm-u = 1
    blockemm-s = 1
    blockemm-g = 1
    audisabled = 1


    its running sweet average 95ms


    i was told to use 003:002 { or whatever your usb is } didn't work :)


    hope this helps ;)

    • Official Post

    There are a few problems with this config that i would change mtv1.


    audisabled = 1 # this will exclude the reader from auto AU/updating entitlements, unless you have a reason for using this, remove it.
    mhz = 600, cardmhz = 600 # this setting doesnt need to be here, its used for internal readers only.
    You are allowing all EMM`s to your card which isn`t advisable, the below config would be better for you.


  • master G

    Set the Label from UK OSCam to Videoguard2 Cards OSCam

Your resource for OSCam softcam

Find configs, downloads, tutorials, and support for setting up and optimizing this open-source card server with wide protocol compatibility. Master the versatile OSCam softcam. Access support, configs, tutorials, and downloads for open-source card sharing and multi-protocol server management.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login