As in the subject. On a mio 4k. Have had a few channels change sats on this side of the pond. I have a couple that are getting control words in the softcam panel.
But no audio or video. Yesterday I tried the recent configs that are posed here. Nothing negative seen on channels that will open.
But the same ones that get control words and no a/v still will not.
I'm still grasping oscam and how it works, so any tips would be a big help.
A bit of live log and configs are attached.
Happy Father's Day all you dads.config.zip LiveLog.txt
Oscam 11523 on Openatv getting cw's but no video/audio
- supwiddiss
- Thread is marked as Resolved.
There are 5 replies in this Thread which was already clicked 1,654 times. The last Post () by Antepenultim8.
-
-
Anyone out there able to give advice?
I left the channel on for over an hour. CW's, no audio/video.
Help? -
I removed cacheex from your emu reader (plus some unneeded options):
Code
Display More[reader] label = emulator protocol = emu device = emulator disablecrccws_only_for = 0E00:000000 caid = 0500,1801,0604,0E00,1010,2600 detect = cd ident = 0500:000000,023800,021110,007400,007800;1801:000000,007301,001101,002111;0604:000000;0E00:000000;1010:000000;2600:000000 group = 1 emmcache = 2,1,2,1 emu_auproviders = 0604:010200;0E00:000000;1010:000000
-
Thanks. It looks like the tp isn't sending any a/v at this time.
Next step is to figure out how to read the ts to verify if it is or not. -
For starters, rescan the transponder, in case they are doing changes in the channels.
-
where is your softcam.key file ?
OSCam-EMU Support Forum
Configs, discussion, downloads and guides for OSCam-EMU Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!