Edison Pingulux Mini blocked software

There are 4 replies in this Thread which was already clicked 1,028 times. The last Post () by wgsjsfhj.

    Hi

    I have Edison Argus Pingulux Mini .

    Probably due to a wrong software update, now the receiver starts and displays the TRUMAN start screen and then writes IDENT ERROR- STB MODEL! and stops with the writing flashing.

    i have flash "spark 7111rescue imange.zip", Accepts the software but then flashes again what I wrote above.

    I don't know what else to do. Am I getting ready to throw it away?

    Thank you

    did you try like this


    Instructions: Flash Enigma2:

    - It is best to reformat the USB stick in FAT32
    - Create folder [enigma2] on the stick
    - Unzip the download and copy the two files "e2jffs2.img" + "uImage" to the folder [enigma2] on the stick
    - Connect the stick to the switched off device
    - When switching on, keep the [OK] key pressed until [FORC] appears
    - Now select [ENIG] with the down arrow key (or P-)
    - Confirm with the right arrow key (or V +) for the update from the USB stick
    - Now the upload to the flash begins, recognizable by [U LD] in the display
    - At the end it comes [SUCC], the device then reboots independently
    - then the E2 initial setup wizard should appear

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login