Hi
I have Edison Argus Pingulux Mini .
Probably due to a wrong software update, now the receiver starts and displays the TRUMAN start screen and then writes IDENT ERROR- STB MODEL! and stops with the writing flashing.
i have flash "spark 7111rescue imange.zip", Accepts the software but then flashes again what I wrote above.
I don't know what else to do. Am I getting ready to throw it away?
Thank you
did you try like this
Instructions: Flash Enigma2:
- It is best to reformat the USB stick in FAT32
- Create folder [enigma2] on the stick
- Unzip the download and copy the two files "e2jffs2.img" + "uImage" to the folder [enigma2] on the stick
- Connect the stick to the switched off device
- When switching on, keep the [OK] key pressed until [FORC] appears
- Now select [ENIG] with the down arrow key (or P-)
- Confirm with the right arrow key (or V +) for the update from the USB stick
- Now the upload to the flash begins, recognizable by [U LD] in the display
- At the end it comes [SUCC], the device then reboots independently
- then the E2 initial setup wizard should appear
Yes but which file do I download?
please try this in attachment, don`t no work, good luck
Edision_Argus_Pingulux_V1.1.29_-_HELP_PACK
Orginal-Firmware 1.2.80 für die Edision Argus Pingulux Serie
I installed openpli-enigma2-5-spark_20170329.zip by TAAPAT with USB and it worked again.
Installation with usb is difficult, try and try again and try again. Then update started.
Thank You
Don’t have an account yet? Register yourself now and be a part of our community!
