Hello.. I have a problem with my spark reloaded 990 on enigma 2 ,, i try a lots of backups
Get this message after screen boot
and when i need back to spark i have this msg
There are 3 replies in this Thread which was already clicked 752 times. The last Post () by ahmed gazye.
Hello.. I have a problem with my spark reloaded 990 on enigma 2 ,, i try a lots of backups
Get this message after screen boot
and when i need back to spark i have this msg
Display MoreHello.. I have a problem with my spark reloaded 990 on enigma 2 ,, i try a lots of backups
Get this message after screen boot
and when i need back to spark i have this msg
Does it work on Spark or the problem with the two systems
If the two systems can apply the way in next topic
Method of passing the rescue-image for Spark devices using Cisco TFTP Server
Thank you for your reply ,, I passed all rescue image to him but when I turn it on to spark
i get this message 0000
if you do not succeed make u-boot
Use at your own risk!
Emergency HowTo: Overwrite boot loader
=======================================
Use only in an emergency!
- Switch off the box, then connect to a PC / laptop using a null modem cable (RS232)
- Start HyperTerminal and create a new connection
-> select correct Com interface
-> Bits per second: 115 200
-> Flow control: none
- Then transfer> send file
- choose correct uboot-xxx.bin
- Protocol: Ymodem
- Click send!
> now switch on the box!
- When switching on, keep the [OK] key pressed until [FORC] appears
- then press the left arrow key [<]
- R232 appears on the display
Now the transmission takes place, which should take about 2 minutes.
Under no circumstances switch off prematurely or other maneuvers in this phase!
If you do not have enough experience, you can go to a specialized technician to recharge the flash drive, which is best
read next topic
Advice when using U-boot in spark boxs
Don’t have an account yet? Register yourself now and be a part of our community!