Friends,
i need a little help. Uno 4k that I have accepts different versions of flash img, each of them passes the installation properly, but after the boot picture I don't have any picture on tv. I connect the device properly via the LAN port and I can open the menus in the web browser. how to enable the device?
VU+ uno 4k boot but no picture
- madarko
- Thread is marked as Resolved.
-
master G
Approved the thread. -
In video settings try lowering the mode/resolution. This setting may be too high for your TV.
-
LAN port? Is that just terminology phrased wrong.
You connect your tv and sat box via the hdmi ports, not the lan port
857b293.png
If your wires are correct.
In a browser use the remote in that and go to
menu/setup/Video/basic settings/ (or similar menus depending on your image)
video output : hdmi
automatic resolution : disabled
mode: drop this down to lowest to see if your tv comes on 720prefresh rate: 50hz (60hz for modern tvs)
-
And you have the Uno 4K and not the Uno 4Kse?? They look simular but the Uno4Kse has a MiniTV and dual Tuners
The Uno4Kse has HDMI in & Out ports so check that you are using the correct port who is HDMI Out to the TV :)
Also have you installed a backup image ??
If so as meantion if your TV is not 4K/UHD then you need to choose a lower resolution.
Backup images comes with all settings done and therefore this can be an issue.
If you install your preferd image from scratch you need to go through all steps and only the correct settings are selctable.
-
VU+ UNO 4K PVR ready Linux Enigma2 Receiver UHD 2160p
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
