Tuner fail in ABM but not in Manual Scan

If this is not in the correct location then please move.

Using an old Worldvision Force1 Plus with triple tuners running openatv 7.2 I have run into a problem when running ABM. If I run Automatic Scan then everything tunes ok, run a Manual Scan and select each tuner in turn and all 3 tune ok, however if I run ABM setting one of the providers as FreeSat UK then tuner B fails. Any help/advise would be appreciated as all tuners appear ok (2 x DVB-S2 & 1 x DVB-T2) My vu+ solo 4K

2023-04-16_174102.png

has no issues using sky or free sat.

Quote from jenseneverest

Not use this is STB before..... i assume tuner A and B are satellite and tuner C is dvb/t ?

So you have 2 satellite feeds and 1 terrestrial plugged in ?

Correct

Quote from abu baniaz

When you scan using tuner B (not using ABM), how many channels did you get? If you go to signal finder, select tuner B and also select the transponder in your screenshot, do you get a lock?

Edit:

Was Solo4K using the same cabling? Or are both receivers connected?

11426H shows nothing but 11426V shows 91% and locked

just rescanning to get number of channels it finds, I think it was around 450 but will confirm when completed

Using different cabling as in different rooms but coming from the same dish.

UPDATE: returns 385 channels

Quote from abu baniaz

OK, we will need to show the polarisation ( vertical/horizontal) in the failure message.

You should be getting over 850 services. Looks like you have a faulty LNB. Some Sky LNBS have a weird fault when two receivers are connected, they fail. For that particular, you would have to test by putting solo 4k in deep standby, not just standby. You can rule out the receiver being at fault by taking it to where the Solo 4K is and using those wires.

I would recommend that you get a unicable LNB to get the most of our Solo 4K.

Thanks, will move the decoder tomorrow morning to where the vu+ is located and see what happens.

Quote from abu baniaz

Off topic. Can you post a picture of your receiver? I am wondering if it is the same OEM as a a Technomate 3T Combo

It works ok when using the cables from the vu+ so something wrong with the other cable feeds from the dish.

Photo as requested and I think it is as you said

IMG_1151.jpg