hi all
got hold on a openbox x3 but dont no the password so i cant use DCC, eny1 have i clue what i could try?
software ver is 3601HD_05_07_2012_0531
ste
There are 15 replies in this Thread which was already clicked 3,056 times. The last Post () by alibaba1802.
hi all
got hold on a openbox x3 but dont no the password so i cant use DCC, eny1 have i clue what i could try?
software ver is 3601HD_05_07_2012_0531
ste
hi, i am not shure you can use dcc on openbox x 3
go to menu and press 6666 then you go to confg ccam newcam ...ect
go to menu and press 6666 then you go to confg ccam newcam ...ect
thanx mate ill have a look in abit
how do i add a c line to the box any1?
ive gone in ccam client setup, manage cofig files then ccam.cfg then blue to add
a box comes up....
protcol should that be CCam
host ******dyndns.org
port *****
user mark
password mate
is that right any1?
QuoteNetwork setup DHCP on press apply / go to CCcam Clinet setup press ok /manage config files press ok / CCcam.cfg press ok / now press the blue buttn to add your cline and then the green to active your cline reboot the box
Quotehost ******dyndns.org
port *****
user mark
password mate
yes , correct..
thanx mate
how do i know the ccam is installed? or wouldnt it say were it protcol is just that you have ccam, avaterCam and andnewcamd
yes thats it s i think is ccam2.14
yes , correct..
still not done tis box lol, doing it now
were it says host do i still put c: *****dyndns.org or just *****dyndns.org?
These boxes are the simplest to set up mate!
In the UI for CCcam setup
Host = myhost@anydns.org
port = 123456
user = user1
pass = pass1
You would only need the c:/f:/n: if you were writing the line in an editor to flash to a box via usb but as the x3/f3 have a UI input screen for it you dont need it!
Hope it helps if you get stuck holla back!
:mrgmx:
thanks for that mate never used 1 befor lol
are they any good? this 1 is my mates just priced them up nice cheep box and its HD
Display MoreThese boxes are the simplest to set up mate!
In the UI for CCcam setup
Host = myhost@anydns.org
port = 123456
user = user1
pass = pass1
You would only need the c:/f:/n: if you were writing the line in an editor to flash to a box via usb but as the x3/f3 have a UI input screen for it you dont need it!
Hope it helps if you get stuck holla back!
:mrgmx:
done that mate now says no active how do i active?
done that mate now says no active how do i active?
Try a reboot, save line first.
thanks for that mate online now
still not done tis box lol, doing it now
were it says host do i still put c: *****dyndns.org or just *****dyndns.org?
If you use a cccam.cfg, c: *****dyndns.org or
If you use the box "editor" , without c:
Don’t have an account yet? Register yourself now and be a part of our community!