hi using bh 1.7.3 still having problems with crosspeg, when i go to mount usb get green screen, then when it boots back usb is mounted when i map it to media usb it doesnt hold, doesnt show in crosspeg configuration, i had this all working before driving me mad , followed all tuts and no joy, any suggestions ?
usb for epg
-
- CrossEPG
- lacierva
- Thread is marked as Resolved.
-
-
uninstall cross epg
get your usb mounting
reinstall cross epg -
on ts panel under tools, uninstal package and remove pluginin folder, there is no crosspeg there to uninstall ???
-
Try going to plugins then remove? perhaps
-
no option to remove in plugins thinking of upgrading to latest bh image to refresh everything cant see whats going on ????
-
lacierva - the bh 1.7.3 is a very nice image,,but if you are thinking of upgrading to 1.7.6 then backup your important files and start from 0 again..
it will take you less time than trying to figure out about crossepg or anything else..
personally i would prefer to find the culprit(cause) of the crash...
but I have never had a greenscreen from crossepg so obviously it is conflicting with something else..
if you could take a capture of the greenscreen it will tell you where/what is causing hte conflict...
another way to uninstall is green-yellow.. there you have other options ...
let us know how you get on..
salu2 -
cazuela, i was half way through re flashing vu when i read your post, now up graded to 1.7.6 and everything is fine, got my usb mapped and it stays recognized in crosspeg, so fingers crossed all ok, thanks for help
-
strange thing though, i have epg ok but now in crosspeg setup the usb its not there, it was before, in crosspeg configure it only gives the option of internal flash nothing else ??
edit :
i think i got it! bh epg is seperate from crosspeg i think, have set it all on bh epgand all is ok fingers crossed
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!
