Tune Failed on Dm800HD PVR with 3 Dishes on DiSEqC switch A B C and on D i have my motorized dish

There are 5 replies in this Thread which was already clicked 3,702 times. The last Post () by saphfire.

    Dear sirs
    This is my first post here and after i done much reading i would like to post my problem ....so i finally find the solution
    I get Tune Failed on my Dm800 HD with newenigma2 img
    I have 3 dishes on switch A B C and on D i have my motorized dish
    many of the channels in all satellite positions giving me Tune failed ....and even if i try to make scan of these satellites i dont get even a single channel
    If im for example on Sly sp 1 and i get this message i have to wait for a min or 2 to get picture


    Im sure my configuration is O K
    What else will be apart from BAd Image?
    Regards

    ok,mormaly you cant put motor on disceq d thats min your configuration cant be a,b,c 3 dishs plus d on motors verry conflictive , or you use only your motor or ude disceq d on your dish with motor but only fix dish, in motor is normal whiting the pictures when you change the satelite .


    and for the rigth setup a /28.2 b/ 19 est .c 13 est d 7est always up to dowt or dowt to up sorry for my english

    Thanks for the reply rami
    Tried everything ...even direct cable for every single dish without the swich...............
    I beileive is the IMAGE cause in other images is working OK but i HaVE to use the newenigma2 img cause its the only one that streaming plugins are working OK
    Thanks again

Your resource for Enigma2 tuner configuration

Find tutorials and support for setting up DVB, advanced FBC, and USB tuners for satellite, cable, and other signal sources. Master your receiver's tuning capabilities. Find dedicated support and guides to configure DVB, FBC, and USB tuners for optimal satellite, cable, and digital TV reception.