Hi;
I am very disappointed with my item Openbox X3. It has been just a few months I am using this.
My device went in constant loop mode after I put some new newcamd lines via update tool.
Before this time, when it went in rebooting mode, I tried several firmwares from the yoja website and I un-bricked the device by loading firmwares using RS232 cable. When it went in bootloop mode, I had the latest firmware (11,02,2012) on the device.
However, this time it is different; I cannot do that.
I can connect it to computer, I can flash the device without interruption, everything goes OK, but after flashing, constant loop goes on; nothing changes.
I tried almost all of the firmwares, I tried even sk/ybox firmwares for S3-M3-S4-M4-S11 etc. etc. I dont have a problem with connecting and flashing the device..
I tried x3 upgrade tool, and I also used 8MFlash tool with no luck. I used almost all firmware and loader combinations. Bootloop goes on. I removed LND, HDMI, ethernet, wifi when I am doing that. Then I tried flashing with them on, but no..
I also wrote to the guys in Yoja, however got no answer from them.
I thought about a heat problem, but bootloop goes on in cold environment, as well.
I am thinking to open the box and then look for a reset chip in it.
Can you help me?