I cannot scan DVB-T frequences on newest SatStation Enigma2 (0 channels found). On spark DVB-T channels works correct.
Please any ideas?
ps. Merry Christmas for Everyone!!
Many thanks
peterr
not sure of setup on amiko but normally I have to setup dtt stick to : config mode enabled - provider: europe dvb-T freqs and active antenna to OFF on enigma2 image..
then do a scan..
...I have tried but still channels not found :(
I have not problem on spark sw
Have you tryed to search manually.
Yes Ben361, I have tried by automatic, tp and manually search :(
I don't understand why on Spark sw everything works correctly.
Peterr, I had something similar and found that within the configuration you need to set it up to correct reciever, is it set to your local receiver? I don't mean UK, I mean regional. I know it says Australia, France...etc, but when you get to the UK you can select a region - could help.
you are in the UK so this may work - I am not sure if there has been any changes since I did this but if there are issues then use the Generic UK set
Some images will not pick dvb-t, I had the same problem. Now using HDMU all is good
I have the same problem on E2 with thve dvb-t/c tuner.
In reception settings: - config mode: enable
- Terestrial provider: Europe, Middle East, asia dvb-c frequencies
- 5v for active antenna: off
) channel find in automatic and manual scan.
I also change in System Control at tunermodus is set on DVB-C.
In Spark is working exelent but not work on media player .
Don’t have an account yet? Register yourself now and be a part of our community!
