please need help thanks

There are 12 replies in this Thread which was already clicked 2,035 times. The last Post () by jay99.

    my box has worked fine in all the time I had it but now if I reboot it or switch it off the box get stuck on booting I have to reflash it every time can any one help
    I have removed the hard drive before flashing it I have also formatted the usb before reflashing thanks

    need oscam 1.20 for my xtrend 9000 I have downloaded loads of them but none seem to install it says installing but when I run sorfcam manager they are not showing up please can some 1 help me thanks

    Quote from jay99

    I have oscam 1.0 and ccam 2.3 but I cant start them both at the same time I can only run 1 or the other


    you can not run more than one EMU at once , onlly one can be Acitve at the time but not both. othrewise you have a combination of emu installed in your box like CCcam+Oscam .

    Virtuosso image xtreame version 3.0 thanks for your help I had it set up before and was using oscam 1.2 and ccam 2.3 I was able to start oscam first then ccam and it worked fine until it got stuck on booting I have fixed that problem now I need a ccam+oscam what will work thanks again

    Quote from darius

    you can not run more than one EMU at once , onlly one can be Acitve at the time but not both. othrewise you have a combination of emu installed in your box like CCcam+Oscam .

    This is the link to download ts panel 7.2 put the ipk on a usb stick vix will prompt you to install it , when done reboot , then go to ts panel and addons youll see linuxsat addons in there you will find vix cams and configs for cards youll get oscam+cccam 213 combo there might be easiest option for you to get going
    Forum Gateway - Powered by DnP Firewall


    Steve

    I have downloaded extracted onto usb,put usb into my box it says no displayable media when I turned the box off to see if it recognised it but it just loaded as normal I then tried to ftp the file to ect then load it but nothing showed up inside local extentions am I doing something wrong thanks

    please forget the last post I have downloaded ts panel now and installed it onto my box but now when I try to install the softcam it says download failed can you help thanks

Firmware, downloads and support for Xtrend.

Your community resource for the Xtrend satellite receiver — firmware images, channel lists, plugins and setup help.