my box has worked fine in all the time I had it but now if I reboot it or switch it off the box get stuck on booting I have to reflash it every time can any one help
I have removed the hard drive before flashing it I have also formatted the usb before reflashing thanks
please need help thanks
- jay99
- Thread is marked as Resolved.
-
-
can u give us a bit more info about your box.l make and model etc
-
sorry its a xtrend 9000 thanks
-
need oscam 1.20 for my xtrend 9000 I have downloaded loads of them but none seem to install it says installing but when I run sorfcam manager they are not showing up please can some 1 help me thanks
-
need oscam 1.20 for my xtrend 9000 I have downloaded loads of them but none seem to install it says installing but when I run sorfcam manager they are not showing up please can some 1 help me thanks
after loadig img. load boot loader as you load img. -
I have boot loader loaded but no oscam 1.20
-
I have oscam 1.0 and ccam 2.3 but I cant start them both at the same time I can only run 1 or the other
-
I have oscam 1.0 and ccam 2.3 but I cant start them both at the same time I can only run 1 or the other
you can not run more than one EMU at once , onlly one can be Acitve at the time but not both. othrewise you have a combination of emu installed in your box like CCcam+Oscam . -
I have oscam 1.0 and ccam 2.3 but I cant start them both at the same time I can only run 1 or the other
Which image are you using buddy ? maybe we can point you in the right direction to the file needed..
-
Virtuosso image xtreame version 3.0 thanks for your help I had it set up before and was using oscam 1.2 and ccam 2.3 I was able to start oscam first then ccam and it worked fine until it got stuck on booting I have fixed that problem now I need a ccam+oscam what will work thanks again
-
you can not run more than one EMU at once , onlly one can be Acitve at the time but not both. othrewise you have a combination of emu installed in your box like CCcam+Oscam .
This is the link to download ts panel 7.2 put the ipk on a usb stick vix will prompt you to install it , when done reboot , then go to ts panel and addons youll see linuxsat addons in there you will find vix cams and configs for cards youll get oscam+cccam 213 combo there might be easiest option for you to get going
Forum Gateway - Powered by DnP FirewallSteve
-
I have downloaded extracted onto usb,put usb into my box it says no displayable media when I turned the box off to see if it recognised it but it just loaded as normal I then tried to ftp the file to ect then load it but nothing showed up inside local extentions am I doing something wrong thanks
-
please forget the last post I have downloaded ts panel now and installed it onto my box but now when I try to install the softcam it says download failed can you help thanks
-
master G
Moved the thread from forum Clarke-Tech | Xtrend Support to forum Xtrend - All Models. -
master G
Moved the thread from forum Xtrend - All Models to forum Xtrend ET-4000. -
master G
Moved the thread from forum Xtrend ET-4000 to forum Xtrend - All Models.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!