pkt team image help

This is what I did.

You need a FAT32 format usb stick, this receiver is fussy with usb stick some recommend using kingston but I found that using the HP usb format tool suggested by someone on this forum got my usb stick working when it didn't previously work.

1.Download your image and unrar you should have a enigma2 folder with 2 files inside it.
2.Place the enigma2 folder fromyour pc onto the usb stick.
3.Whilst you receiver is off press the 'ok' and keep on pressing it down and power up you receiver until your see FORC on the receivers display.
4.Press the down channel button 'v' you should see the display change to ENIG press 'ok button when display say SUCC switch off your reciever.
5.Put you usb stick into your receiver and once again power on receiver whilst pressing 'ok' button untilyou see FORC.
6.Press the up volume button '>' you should see the display change to FACT press 'ok'
7.If everything is al-right then you should see U_LOAD you just wait until image is installed and at the end it will boot up.
8.If you see 7 77 then either you need to use another usb stick or you have not put the proper enigma2 folder on to usb stick.

Good Luck.

I use the PKT image you only need the one folder the 'enigma2' there are two files in that folder you put the whole 'enigma2' folder onto the usb stick and follow instructions.

Good luck.

I had trouble with tsmedia when I updated it I lost my openwebif so next time I used media portal see this thread here.