hi all i wanna connect my dm 500 to my laptop via ethernet cable and my laptop is running a unlimited usb dongle.My laptop has windows 7 on and id like to kno what conections i have to set up on my laptop
Dm500 to 3G usb dongle
- sloshed
- Thread is marked as Resolved.
There are 6 replies in this Thread which was already clicked 3,441 times. The last Post () by newtolinux.
-
-
yes you can do it mate! share the usb connection as you would a Ethernet connection in windows 7! And set the rest up using dhcp!
-
Its possible some how..
I've seen a spiderbox done this way and it was fine so i assume it'll be grand too..
Another option is one of these eBay.ie: Belkin Wifi Wireless Starter Modem Router & USB Dongle (item 200552690753 end time 07-May-11 17:17:15 BST)
Reads the sim of your wireless dongle and acts like a normal house outer..
Giving you wi-fi and ethernet outputs for the dm500s, etc!...
-
esr how co i do that conection mate
-
Very easy mate
Install your usb broadband dongle as normal
Connect laptop to dream etc via ethernet cable( must be a crossover type ) unless you use a network switch
Setup internet connection sharing within windows on your mobile broadband connection
Assign your laptop a static ip on the lan of say 192.168.1.1
Assign your receiver a static ip of say 192.168.1.2
All being well your box should now have internet connectivity . Just be aware that some mobile broadband providers have there own NAT on network and certain ports are blocked. So you may need to experiment .
thx
t
-
hi
How to connect dream box using 3g, GPRS or HSPA
1. Connect your USB dongle to computer and connect to the internet.
2. goto run menu and type cmd or
accessories Command Prompt/ Programs /start
3. you will get dos command screen
4. type ipconfig
5. You will be given two ip settings, you might see on top 192.168.0.1 or some ip range.
7. Connect your dream box to tv and connect your computer also, if you connect using directly, you should use cross cable to connect your computer.
8. you should share your network connection, to do that
network connections / settings
9. start select your 3G or GPRS connection.
10. click right mouse button and select properties and select advance tab on the dialog box and on the internet connection sharing tab select allow user to share my internet connectionclick ok button and close it
Then go to dreambox on the set ip address as if you computer ip communication settings settings menu is 192.168.0.1 then select your ip as 192.168.0.2 then Set gateway as your computer ip “192.168.0.1” and name server also same ip rest of the things same.
Save it and close
Wait till online comes and try to browse channels
-
& dont forget to open your windows firewall ports on your shared internet connection to allow your cccam server port traffic if you are also hosting a card via this method . You may have to experiment a bit with ports as some mobile isp's block ports from within their own network and theres not much you can do about it . Ping time is the biggest factor for you in mobile broadband . You will find it very hard to watch certain n$s cards if you have a bad 3g signal wherever you are.
regardsnew2
-
master G
Moved the thread from forum DM500 - DM500s Support to forum Enigma1 Support.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!