Tuner Configeration

There are 2 replies in this Thread which was already clicked 847 times. The last Post () by carrier.

    Quote from carrier

    Hello, I know that you can change your Lat and Long settings when you do a factory reset but when you go to menu and tuner config you see your settings,but I cannot change them there?


    ********************************************
    menu>set up>ok>service searching>ok>tuner configuration>
    on tuner A >ok>set tuner to simple> mode to postioner then you scroll
    down to the long and lat settings and enter or change the setting
    with numbered keys on the remote

    Thanks for that, it works, don't know what I was doing. I think I went straight in to the set up positions and without changing the simple and positioner, tried to change the lat and long settings and it did'nt. Thanks for response.

Your resource for Enigma2 tuner configuration

Find tutorials and support for setting up DVB, advanced FBC, and USB tuners for satellite, cable, and other signal sources. Master your receiver's tuning capabilities. Find dedicated support and guides to configure DVB, FBC, and USB tuners for optimal satellite, cable, and digital TV reception.