Can't get anything to clear on mgcam on the above image??
I'm using tenbelows backup image and has mg1.38 installed.
I've tried version 1.35a manual install and another ipk version but nothing clears.
I've also edited the mg_cfg to suit but still nothing.
I'm using a vu solo2 and Cccam works fine but mgcam is doing my but.
I had it working fine on an older image but don't want to revert to it...wanna remain up to date.
Has anyone got a known working link to this cam??
Cheers
Mgcam and Black hole 2.0.9
- freck
- Thread is marked as Resolved.
-
-
I tested this before posting the 2.0.8 backup (never made one for 2.0.9) and all was good buddy, all you should need to do is add your line to the cccamd.list file then restart mgcamd 1.3.8.
-
I'm adding line to newcamd.list file....I'll try it again.Yeah its the 2.0.8 backup
-
I'm adding line to newcamd.list file....I'll try it again.Yeah its the 2.0.8 backup
Ok sorry i assumed it was a cline, you may need to edit the mgcamd.cfg in that case like this buddy.# network mode, use summ for several clients
# 00 no network (default)
# 01 newcamd netclient
# 02 radegast netclient
# 04 camd3 netclient
# 08 gbox netclient
G: { 01 } -
Still no connect...stumped??
Gotta walk away from it for a while...grrrr -
I hate to intrude, but I now have the above working fine using mgcamd 1.38bh . In my mg cfg. file however G is set to 33 and B is set to 6. This is on the duo but I don't think it's any different. I assume you tried downloading a fresh version of 1.38 . I have had issues with back ups in the past! Hope it all works in the end for you buddy.
-
as a far as i'm aware, setting G to { 33 } lets you run cccam and newcamd
-
as a far as i'm aware, setting G to { 33 } lets you run cccam and newcamd
yes thats what ive gor on my duo with cccam 2.3.0 and mgcamd 1.3.8 working fine... -
have you got c and f lines set in the cccamd list?
MGCamd Support Forum
Configs, discussion, downloads and guides for MGCamd Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!