I've no 12v 3 amp adapters. Had a 12v 1 amp, tried it and nothing. Only other one I have is a 20v 4 amp. I think it's time I started saving for a new box :(
Motor not turning
-
- Motor Support
- anfieldoreill
- Thread is marked as Resolved.
-
-
i would be looking at the psu as some dm's were supplied with a 1 amp/12v psu as the dm can use most of this 1 amp not good enough for motor+dm (some ext..hdd's supply psu's with 3 amp) ps..DONT use the 20volt
-
Thanks annie , no I didn't use the 20v. I went out today and bough an inet500s, it's another clone. And it's moving the dish . So I'm over the noon :) . Have one more problem though it's off topic so I'll post it in another section . Thanks everyone for your help.
-
Did you try your new power supply with your old box?
-
no m8 i didnt have any, and was having nothing but hassle with that box, so got a replacement.
-
I mean, when you got your new one, try the new power supply in your old box. If it works then you only need to get a power supply of eBay to have another box.
General Satellite & Installation Support Forum
Support for LNBs, Single satellite, motorised and multi-satellite systems. DiSEqC switches, positioners, motors, actuators, dish-alignment help.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!