I hope someone may be able to help. I am trying a basic setup on a newly purchased xpeed lx2.
I get to the configuring the tuner A and B stage and then come to a halt. The problem is that
A sets up fine but B keeps coming up as nothing connected. I am setting configuring mode as simple.
Next mode as DISEqC A/B, Port A shows 28.2E Eutalsat etc Port B shows nothing connected. I have
swapped over the double feed in from the sat dish to no avail. As you can tell I am a complete novice
who has bought a set top box with little support at the moment.
There are 6 replies in this Thread which was already clicked 1,517 times. The last Post () by franceene.
-
-
So what is it your trying to achieve mate.
Is it the same sat on both tuners?? i.e. 28.2e -
Yes that is it then hopefully I can set up an external hard drive and record a program whilst watching
another one. -
Just guessing here, but if you have a twin LNB with two feeds from it and a twin tuner, why do you need a diseqc switch?
Just take it out and set tuner A equal to tuner B. -
When I try to set it up in that mode I get no channels showing.In tuner configuration it shows Tuner A DVB-S2 INTERNAL(DVB-S2) equal to tuner B.
Tuner B DVB-S2 NIM(DVB-S2) equal to tuner A
I then try on auto scan and manual scan which show Nothing to scan. Please setup your tuner settings before you scan. -
Add the attached channel list and setup both tuners the same as how it is in the image below..
-
I have channels now.Thank you all for your help. If I cannot find out the info I need to set up my xpeed lx2 and need further guidance(if offered of course)
is this the correct forum to ask.
Firmware, downloads and support for Golden Interstar Xpeed.
Your community resource for the Golden Interstar Xpeed satellite receiver — firmware images, channel lists, plugins and setup help.
