Update
OK back on debian with smargo and all ok? Dont understand why I cant update to the latest oscam image tho???
cheers for feedback guys
Update
OK back on debian with smargo and all ok? Dont understand why I cant update to the latest oscam image tho???
cheers for feedback guys
Here is something that may interest you, How to : infinity usb smart win7 32/64 oscam setup
Hi Master g this is not an infinity usb smart its this version.. WB Electronics
version 1.6 build 1529. I have the latest drivers Jan 2011. It is set to boot up in pheonix mode with frequency of 3.579 mhz so all looks good there. As stated am back on debian now but it wont do an update to the latest oscam as stated.
cheers guys
Your previous post on updating
Should be (as you say you want to install the latest version)
If you want to install a specific version, then you need to specify which one it is you want
Thanks LFC. I was following the tut here http://linuxsat-support.com/os…iots-guide-compiling.html by new2linux and towards the end it says this to update to a later version next time....
TO COMPILE LATEST VERSION NEXT TIME
************************************
cd /usr/src
svn co oscam - Revision 5352: /trunk oscam
cd /usr/src/oscam/build
cmake ..
make
then
NOW WE WILL COPY OSCAM TO /USR/LOCAL/BIN
*****************************************
cp oscam /usr/local/bin
cd /usr/local/bin
ls
(oscam should be listed here. Next: )
chmod 755 oscam
Is this not the case then??
AH!
I'm thinking as you have now rebuilt from scratch that you have followed the guide from the start again? as the files would need to be in /usr/src for you to check for new version.
Then you would be able to simply do the upgrade method once all the files have been put in place.
Hi LFC thanks for reply. I didn't rebuild from scratch. I installed from scratch a few weeks ago and just want to update to latest oscam version so just tried to do from step indicated above but get that error message
Im using oscam/cccam on dm500 server, cccam conecting cliants to oscam
i have this line in oscam user:au = lower card
do i need to change it to:au = 1
or do i change something in cccam.conf to get card updates.
sorry about the noob questions
Don’t have an account yet? Register yourself now and be a part of our community!