[How-To] Update Firmware On Golden Interstar Xpeed LX Receiver

There are 4 replies in this Thread which was already clicked 5,619 times. The last Post () by gg69me.

    • Official Post


    - Copy the Firmware to a USB device
    - Unzip the Firmware in USB device
    - After unzip you will get folder "xpeedlx"
    - Switch off your Receiver in rear side with power switch
    - Insert the USB device to any USB port
    - Switch on the Receiver by power switch
    - Update will start automatically
    - If update finish the Receiver will show message in display
    - Switch off the Receiver by power switch
    - Remove the USB device
    - Switch on Receiver by power switch
    - Done

    It will only start automatically if you have the force file. If it said noforce then change the name to force for auto flash.


    Sent from my SM-G900F using Tapatalk

    is updating the firmware the same as flashing an image . i am thinking of flashing a new image as the one i have is pretty old and crashes alot . i want a good stable image , all the bells and whistles are nt necessary so any recommendations guys.....

    Thanks Codar , i was wondering if you were still around . All your advice in the past has been spot on so i will take on board your suggestion and check out the above image in the next day or two when i get a chance...thanks again

Firmware, downloads and support for Golden Interstar Xpeed.

Your community resource for the Golden Interstar Xpeed satellite receiver — firmware images, channel lists, plugins and setup help.